Change the local group number to 255 or less and request that the remote data center
matches the group member in its configuration.

Set the local group number as 300 in the remote data center configuration

Run version 1 and version 2 HSRP on VLAN300 in the local data center.

Reduce the priority of the local HSRP to below 100 to force the local HSRP to standby
and then change the version to version 1.

The host has not responded to the Control Sub-TLV DCBX exchanges of the switch.

The acknowledgement number in the server response has not incremented for 100
exchanges.

Cisco Discovery Protocol is disabled on the switch.

LLDP is disabled on the switch

event statement

event-default action statement

policy-default action statement

IP address of the SNMP server

Remove all of the local storage that is installed

Delete and reconfigure the pWWN of the SAN boot target

Remove all of the ISO images that are mounted as a virtual CD-ROM

Delete and reconfigure the boot LUN

Save the system image in NVRAM.

Use the same system image as the kickstart image.

Load a new system image.

Reload the same system image.

Acknowledge the primary fabric interconnect.

Remove the service pack from the subordinate fabric interconnect.

Clear the startup version of the default infrastructure pack.

Upgrade the firmware of the infrastructure firmware by using the force o

The event timer must be written in epoch time format.

The Cisco Nexus switch must be configured with one applet because a configuration
with two applets will fail.

The Cron entry must be configured without double quotes.

The applet called “Backup” must include an action to remove the current static rout

Add the FCoE VLAN to the allowed VLAN list.

Configure the FCoE VLAN that corresponds to the vFC VSAN as a private VLAN.

Configure the interface as a trunk port.

Configure the interface to use the native VLAN of the trunk port.