Drag and drop the model-driven telemetry considerations from the left onto the modes they
apply to on the right.

An architect must create a QoS solution for a customer to ensure that a 40 Mbps Internet
connection is shared between four subnets based on these requirements:
* Each subnet must receive no less than 10 Mbps of download bandwidth during peak
traffic times.
* A subnet can use up to 40 Mbps during nonpeak traffic times if the other subnets are idle.
* Download traffic must never experience a delay.
Which solution must the architect choose?

How are wireless endpoints registered in the HTDB in a Cisco SD-Access architecture?

Which design consideration should be observed when EIGRP is configured on Data Center
switches?

Refer to the exhibit.

An architect must design an IPv6 migration solution for an enterprise customer to support
these requirements:
* Clients will transition to the new IPv6 network, which provides NAT64 and IPv6 DNS
resolution services, using the same DNS name that points to the IPv4 address.

* The service provider will create a client-facing IPv6 interface with a new IPv6 virtual
address that points to the same IPv4 DNS server.
* The service provider will support clients that use global IPv6 addresses and encapsulate
IPv4 packets into IPv6 tunnels.
Which two migration solutions must the architect choose? (Choose two.)

Refer to the exhibit. A customer needs to apply QoS to the network management traffic
passing through the GigabitEthernet0/2 interface. All eight queuing classes are in use, so
the new requirement must be integrated into the existing policy. Which solution must the
customer choose?

An ISP provides Layer 3 VPN service over MPLS to a customer with four branches and
multiple CE routers at
each branch. To exchange the routes that are learned from the CE routers, which BGP
address family should
the ISP activate among the PE routers?

Refer to the exhibit

A network engineer must improve the current IS-IS environment. The Catalyst switch is
equipped with dual supervisors. Each time a stateful switchover occurs, the network
experiences unnecessary route recomputation. Which solution addresses this issue if the
upstream router does not understand graceful restart messaging?