Discount Offer

Why Buy NSE7_EFW-7.2 Exam Dumps From Passin1Day?

Having thousands of NSE7_EFW-7.2 customers with 99% passing rate, passin1day has a big success story. We are providing fully Fortinet exam passing assurance to our customers. You can purchase Fortinet NSE 7 - Enterprise Firewall 7.2 exam dumps with full confidence and pass exam.

NSE7_EFW-7.2 Practice Questions

Question # 1
Which ADVPN configuration must be configured using a script on fortiManager, when using VPN Manager to manage fortiGate VPN tunnels?
A. Enable AD-VPN in IPsec phase 1
B. Disable add-route on hub
C. Configure IP addresses on IPsec virtual interlaces
D. Set protected network to all


A. Enable AD-VPN in IPsec phase 1

Explanation:

To enable AD-VPN, you need to edit an SD-WAN overlay template and enable the Auto-Discovery VPN toggle. This will automatically add the required settings to the IPsec template and the BGP template. You cannot enable AD-VPN directly in the IPsec phase 1 settings using VPN Manager.

References := ADVPN | FortiManager 7.2.0 - Fortinet Documentation


Question # 2
Which two statements about the BFD parameter in BGP are true? (Choose two.)
A. It allows failure detection in less than one second.
B. The two routers must be connected to the same subnet.
C. It is supported for neighbors over multiple hops.
D. It detects only two-way failures.


A. It allows failure detection in less than one second.
C. It is supported for neighbors over multiple hops.

Explanation: Bidirectional Forwarding Detection (BFD) is a rapid protocol for detecting failures in the forwarding path between two adjacent routers, including interfaces, data links, and forwarding planes. BFD is designed to detect forwarding path failures in a very short amount of time, often less than one second, which is significantly faster than traditional failure detection mechanisms like hold-down timers in routing protocols. Fortinet supports BFD for BGP, and it can be used over multiple hops, which allows the detection of failures even if the BGP peers are not directly connected. This functionality enhances the ability to maintain stable BGP sessions over a wider network topology and is documented in Fortinet's guides.


Question # 3
Which two statements about IKE vision 2 are true? (Choose two.)
A. Phase 1 includes main mode
B. It supports the extensible authentication protocol (EAP)
C. It supports the XAuth protocol.
D. It exchanges a minimum of four messages to establish a secure tunnel


B. It supports the extensible authentication protocol (EAP)
D. It exchanges a minimum of four messages to establish a secure tunnel

Explanation:

IKE version 2 supports the extensible authentication protocol (EAP), which allows for more flexible and secure authentication methods1. IKE version 2 also exchanges a minimum of four messages to establish a secure tunnel, which is more efficient than IKE version 12. References: = IKE settings | FortiClient 7.2.2 - Fortinet Documentation, Technical Tip: How to configure IKE version 1 or 2 … - Fortinet Community



Question # 4
Which two statements about metadata variables are true? (Choose two.)

A. You create them on FortiGate
B. They apply only to non-firewall objects.
C. The metadata format is $.
D. They can be used as variables in scripts


A. You create them on FortiGate
D. They can be used as variables in scripts

Explanation:

Metadata variables in FortiGate are created to store metadata associated with different FortiGate features. These variables can be used in various configurations and scripts to dynamically replace the variable with its actual value during processing. A: You create metadata variables on FortiGate. They are used to store metadata for FortiGate features and can be called upon in different configurations. D: They can be used as variables in scripts. Metadata variables are utilized within the scripts to dynamically insert values as per the context when the script runs.

Fortinet FortiOS Handbook: CLI Reference



Question # 5
How are bulk configuration changes made using FortiManager CLI scripts? (Choose two.)
A. When run on the Device Database, changes are applied directly to the managed FortiGate device.
B. When run on the Remote FortiGate directly, administrators do not have the option to review the changes prior to installation.
C. When run on the All FortiGate in ADOM, changes are automatically installed without the creation of a new revision history.
D. When run on the Policy Package, ADOM database, you must use the installation wizard to apply the changes to the managed FortiGate device.


B. When run on the Remote FortiGate directly, administrators do not have the option to review the changes prior to installation.
D. When run on the Policy Package, ADOM database, you must use the installation wizard to apply the changes to the managed FortiGate device.



Question # 6
Which statement about the designated router (DR) and backup designated router (BDR) in an OSPF multi-access network is true?
A. Only the DR receives link state information from non-DR routers.
B. Non-DR and non-BDR routers form full adjacencies to DR only.
C. FortiGate first checks the OSPF ID to elect a DR.
D. Non-DR and non-BDR routers send link state updates and acknowledgements to 224.0.0.6.


B. Non-DR and non-BDR routers form full adjacencies to DR only.



Question # 7
Refer to the exhibit, which shows two configured FortiGate devices and peering over FGSP.

A. To have both sessions and configuration synchronization in layer 2
B. To load balance both sessions and configuration synchronization between layer 2 and 3
C. To have only configuration synchronization in layer 3
D. To have both sessions and configuration synchronization in layer 3


D. To have both sessions and configuration synchronization in layer 3

Explanation:
The primary purpose of configuring a main link between the devices is to synchronize session information so that if one unit fails, the other can continue processing traffic without dropping active sessions.
A. To have both sessions and configuration synchronization in layer 2.This is incorrect because FGSP is used for session synchronization, not configuration synchronization.
B. To load balance both sessions and configuration synchronization between layer 2 and 3.FGSP does not perform load balancing and is not used for configuration synchronization.
C. To have only configuration synchronization in layer 3.The main link is not used solely for configuration synchronization.
D. To have both sessions and configuration synchronization in layer 3. The main link in an FGSP setup is indeed used to synchronize session information across the devices, and it operates at layer 3 since it uses IP addresses to establish the peering.


Question # 8
Refer to the exhibit, which shows a partial web filter profile conjuration.

What can you cone udo from this configuration about access to www.facebook, com, which is categorized as Social Networking?
A. The access is blocked based on the Content Filter configuration
B. The access is allowed based on the FortiGuard Category Based Filter configuration
C. The access is blocked based on the URL Filter configuration
D. The access is hocked if the local or the public FortiGuard server does not reply


C. The access is blocked based on the URL Filter configuration

Explanation: The access to www.facebook.com is blocked based on the URL Filter configuration. In the exhibit, it shows that the URL “www.facebook.com” is specifically set to “Block” under the URL Filter section1.


NSE7_EFW-7.2 Dumps
  • Up-to-Date NSE7_EFW-7.2 Exam Dumps
  • Valid Questions Answers
  • Fortinet NSE 7 - Enterprise Firewall 7.2 PDF & Online Test Engine Format
  • 3 Months Free Updates
  • Dedicated Customer Support
  • NSE 7 Network Security Architect Pass in 1 Day For Sure
  • SSL Secure Protected Site
  • Exam Passing Assurance
  • 98% NSE7_EFW-7.2 Exam Success Rate
  • Valid for All Countries

Fortinet NSE7_EFW-7.2 Exam Dumps

Exam Name: Fortinet NSE 7 - Enterprise Firewall 7.2
Certification Name: NSE 7 Network Security Architect

Fortinet NSE7_EFW-7.2 exam dumps are created by industry top professionals and after that its also verified by expert team. We are providing you updated Fortinet NSE 7 - Enterprise Firewall 7.2 exam questions answers. We keep updating our NSE 7 Network Security Architect practice test according to real exam. So prepare from our latest questions answers and pass your exam.

  • Total Questions: 64
  • Last Updation Date: 15-Apr-2025

Up-to-Date

We always provide up-to-date NSE7_EFW-7.2 exam dumps to our clients. Keep checking website for updates and download.

Excellence

Quality and excellence of our Fortinet NSE 7 - Enterprise Firewall 7.2 practice questions are above customers expectations. Contact live chat to know more.

Success

Your SUCCESS is assured with the NSE7_EFW-7.2 exam questions of passin1day.com. Just Buy, Prepare and PASS!

Quality

All our braindumps are verified with their correct answers. Download NSE 7 Network Security Architect Practice tests in a printable PDF format.

Basic

$80

Any 3 Exams of Your Choice

3 Exams PDF + Online Test Engine

Buy Now
Premium

$100

Any 4 Exams of Your Choice

4 Exams PDF + Online Test Engine

Buy Now
Gold

$125

Any 5 Exams of Your Choice

5 Exams PDF + Online Test Engine

Buy Now

Passin1Day has a big success story in last 12 years with a long list of satisfied customers.

We are UK based company, selling NSE7_EFW-7.2 practice test questions answers. We have a team of 34 people in Research, Writing, QA, Sales, Support and Marketing departments and helping people get success in their life.

We dont have a single unsatisfied Fortinet customer in this time. Our customers are our asset and precious to us more than their money.

NSE7_EFW-7.2 Dumps

We have recently updated Fortinet NSE7_EFW-7.2 dumps study guide. You can use our NSE 7 Network Security Architect braindumps and pass your exam in just 24 hours. Our Fortinet NSE 7 - Enterprise Firewall 7.2 real exam contains latest questions. We are providing Fortinet NSE7_EFW-7.2 dumps with updates for 3 months. You can purchase in advance and start studying. Whenever Fortinet update Fortinet NSE 7 - Enterprise Firewall 7.2 exam, we also update our file with new questions. Passin1day is here to provide real NSE7_EFW-7.2 exam questions to people who find it difficult to pass exam

NSE 7 Network Security Architect can advance your marketability and prove to be a key to differentiating you from those who have no certification and Passin1day is there to help you pass exam with NSE7_EFW-7.2 dumps. Fortinet Certifications demonstrate your competence and make your discerning employers recognize that Fortinet NSE 7 - Enterprise Firewall 7.2 certified employees are more valuable to their organizations and customers.


We have helped thousands of customers so far in achieving their goals. Our excellent comprehensive Fortinet exam dumps will enable you to pass your certification NSE 7 Network Security Architect exam in just a single try. Passin1day is offering NSE7_EFW-7.2 braindumps which are accurate and of high-quality verified by the IT professionals.

Candidates can instantly download NSE 7 Network Security Architect dumps and access them at any device after purchase. Online Fortinet NSE 7 - Enterprise Firewall 7.2 practice tests are planned and designed to prepare you completely for the real Fortinet exam condition. Free NSE7_EFW-7.2 dumps demos can be available on customer’s demand to check before placing an order.


What Our Customers Say